Loading... Please wait...

Fourth of July Flag Bow Tutorial

Posted

MAIN

This fun bow is easy to make and just in time for the 4th!

What you'll need:
1.5" ribbon in both blue/white polka dot and red/white striped ribbon
scissors
needle and sewing thread
hot glue gun
marking pen
hair clip
lighter or fray check

Step 1

STEP_1

Start by measuring and marking your ribbon. Cut 1 striped piece 5" long. Cut another striped piece 18.25" long. Mark it in 6" sections with a .25" section at the end. (Don't worry - the marks will all get covered.) Cut 1 polka dot piece 6.25" long. Mark it .25" from the end. Seal the ends of the ribbon with a lighter or fray check so they do not fray while you are working.

Step 2

STEP_2

Knot a length of thread and sew a running stitch along the edge of the striped ribbon. Loop the ribbon over to match up and sew along the marks you made. When you get to the end of the striped ribbon, overlap the .25" section of the stripe with the .25" section of the polka dot, lining up the marks, and continue sewing the running stitch to the end. (Note: if your ribbon is only printed on one side, it is important that you loop it in a spiral pattern as pictured instead of zig-zagging it back and forth so that the printed side always ends up facing out.)

Step 3

STEP_3

Slide all the ribbon down the thread towards the knot so it gathers and forms 4 nice loops. Hold together with your fingers and use the leftover tail of thread to wrap tightly around the gathered ribbon, securing the loops in place. Tie off and snip the thread.

Step 4

STEP_4

Take the 5" section of the striped ribbon, fold in thirds, then knot loosely in the middle.

Step 5

STEP_5

Put a dab of hot glue on the back of the knot and attach it to the front of the bow, covering the threads. Make sure the polka dots are in the top left position.

Step 6

STEP_6

Turn the bow over so the back side is facing you. Fold up the bottom end of the knotted ribbon and secure with hot glue to the back of the bow. (You may need to trim the ends a little if they are too long.) Attach the hair clip to the top end of the knotted ribbon with the top side of the clip facing up.

Step 7

STEP_7

Fold the end of the ribbon over the clip and secure with glue.

Step 8

STEP_8

Fold over again and secure with glue for a nice finished look.

Step 9

STEP_9

Sit back and admire your work!

comments powered by Disqus

 

Recent Updates

Connect with us

Newsletter